Lo-Chlor Iron Stain Remover
The Lo-Chlor Iron Stain Remover (1 kg) is a high strength formulation developed to remove brown iron stains from swimming pool surfaces. Containing a special acid blend, it dissolves iron deposits that cause rust-like discolouration in pools, helping to restore clean and bright finishes. This product is effective on fibreglass, plaster, and vinyl-lined pools, though special care must be taken with certain finishes.
Category – Pool Chemicals
Key Features of Lo-Chlor Iron Stain Remover
- High strength formulation – Designed to target and remove brown iron stains.
- Specialised acid blend – Developed specifically for swimming pool surfaces.
- Fast acting – Works quickly when chlorine levels are lowered.
- Versatile application – Can be sprinkled directly on stains or evenly distributed across the pool.
- Spot treatment option – Suitable for smaller stains using a sock or stocking method.
- Restores pool appearance – Eliminates iron discolouration and improves water clarity.
Specifications
| Feature | Details |
|---|---|
| Product Type | Pool and Spa Chemical – Iron Stain Remover |
| Brand | Lo-Chlor |
| Model | 70ISR1K |
| Active Function | Removes brown iron stains from pool surfaces |
| Application | General water dosing or spot treatment |
| Dosage | 1 kg per 50,000 L of pool water |
| Compatibility | Suitable for most pool finishes. Special care required for quartzon, coloured pebble, coloured marble, exposed aggregate, and printed vinyl liners |
| Sizes Available | 1 kg container |
Application Instructions
- Allow free chlorine levels to fall below 0.5 ppm by switching off the salt chlorinator or using Lo-Chlor Chlorine Remover.
- Adjust pH to between 7.2 and 7.6.
- Add 1 kg of Lo-Chlor Iron Stain Remover per 50,000 litres of pool water with the pump and filter running.
- The product may be sprinkled directly over the stained area or evenly distributed around the pool.
- Caution: For pools with quartzon, coloured pebble, coloured marble, exposed aggregate finishes, or printed vinyl liners, do not allow direct contact with surfaces. In these cases, dissolve the product in a bucket of water and disperse evenly.
- Run pump and filter for at least 24 hours, then resume normal filtration.
- Rebalance the pool water after treatment. Consult a pool professional if necessary.
Following the directions for use, brown iron stains can be removed quickly and efficiently within several hours.
Spot Staining Method
For less severe stains:
- Place a small amount of Lo-Chlor Iron Stain Remover into a sock or stocking.
- Attach it to the end of a telepole.
- Hold it close to, but not directly on, the stain for several minutes.
- If no improvement occurs, revert to the full treatment procedure.
Important Notes
- Most iron staining occurs due to incorrectly balanced water.
- Product will not be effective if chlorine levels are too high.
- Always follow safety directions and label instructions.
Frequently asked questions
Our FAQ area is the best place to look to find answers to your questions. Our community and support team
constantly updates the questions and answers.
It removes brown iron stains from swimming pool surfaces caused by dissolved iron.
Yes, but only on standard finishes. For quartzon, coloured pebble, coloured marble, exposed aggregate, and printed vinyl liners, always pre-dissolve in a bucket before adding.
One 1 kg container treats up to 50,000 litres of pool water.
Yes. Free chlorine levels must be reduced to below 0.5 ppm before use for the treatment to work effectively.
You can use the spot stain method by placing the product in a sock or stocking and holding it near the stain.
They are typically caused by incorrectly balanced water or by filling pools with iron-rich source water.
